Echelon i.LON 10 Guia do Utilizador descarregar pdf (Página 11)

Security Access Reset

The following features of the i.LON 10 Ethernet Adapter are available only after

performing a security access reset:

• Access to the MD5 Authentication Key on the setup web page (see i.LON 10

Ethernet Adapter Setup Web Page, earlier in this chapter).

• Access to the Display Factory Defaults button on the setup web page.

• Access to the security web page (see i.LON 10 Ethernet Adapter Security Web

Page, earlier in this chapter).

• Access to the Perform Self-Test web page. See the i.LON 10 Ethernet

Adapter User’s Guide for more information.

• Access to the firmware upgrade web page.

A security access reset of the i.LON Ethernet Adapter requires physical access to

the i.LON 10 hardware. To perform a security access reset, follow these steps:

1. Remove the i.LON 10 Ethernet Adapter from the TCP/IP network and attach

it to the PC using a crossover Ethernet cable or a local server hub.

2. Disconnect the power supply from the i.LON 10 Ethernet Adapter.

3. Press and hold the service pin on the i.LON 10 Ethernet Adapter using a

ballpoint pen or similar device.

4. Reconnect the power supply to the i.LON 10 Ethernet Adapter while still

pressing in the service pin.

5. Continue holding the service pin. In approximately 10 seconds the wink and

connect LEDs will illuminate. Release the service pin.

The i.LON 10 Ethernet Adapter will now be in security access mode. When the

i.LON 10 Ethernet Adapter is in security access mode, its IP address is

temporarily changed to 192.168.1.222 and the user name and password are

set to ilon/ilon; they are changed back to the values specified on the Setup and

Security web pages once the i.LON 10 exits security access mode. When in

security access mode you can access the Security web page and the other features

listed above until the i.LON 10 is reset.

i.LON 10 Ethernet Adapter Security Web Page

Access the Security web page by clicking the Security link from the Setup web

page. This page is only accessible after a security access reset. This page

appears as shown in the following figure:

i.LON 10 Ethernet Adapter Quick Start Guide 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sem comentários

Echelon i.LON 10 Guia do Utilizador Página 11