Echelon NodeLoad Utility Manual do Utilizador descarregar pdf (Página 9)

Passing Result

This result message indicates passing results and returns the NID of the loaded node.

Nodeload Result: Success; NID=050001020300

Failing Result

This result message indicates failing results and includes a code that specifies

the failure.

Nodeload Result: Failed (error - #x)

Error Code Reference

Error codes for the NodeLoad utility (error - #x) are defined in the

following table.

Error Code Error Title Description

No nodes found The “-Q” switch was specified and no devices were

found during the query.

Service pin timeout The “-W” switch was specified and no service pin

message was received.

Comm failure A communication failure occurred either on initial

contact with the “-N” switch or subsequent contact in

any mode.

File error The NDL file was not found or was corrupted.

Reset failure Nodeload could not successfully cause the node to

reset. This could indicate an excessively long reset

clause in the application.

Buffer failure Nodeload could not successfully configure the buffers

on the network interface.

State failure The device could not be successfully put into the

correct state at the end of the load.

Checksum failure The device failed to set its checksum after the load.

Version mismatch The device firmware version didn’t match the firmware

version that the NDL file was linked for.

Model mismatch The device model number (that is, part type) did not

match the model number that the NDL file was linked

for.

Interface error The network interface (for example, U10) could not be

communicated with.

Response error The device reported a failing response. This could be

due to an authentication key mismatch or a failure to

write non-volatile memory.

NodeLoad Utility User’s Guide

1 2 3 4 5 6 7 8 9 10

Sem comentários

Echelon NodeLoad Utility Manual do Utilizador Página 9